Arduino Sensor Shield V5 0 Manual May 2026

void loop() // Sweep from 0 to 180 degrees for (pos = 0; pos <= 180; pos++) myservo.write(pos); delay(15); int distance = readUltrasonic(); Serial.print("Angle: "); Serial.print(pos); Serial.print(" cm: "); Serial.println(distance);

int readUltrasonic() digitalWrite(trigPin, LOW); delayMicroseconds(2); digitalWrite(trigPin, HIGH); delayMicroseconds(10); digitalWrite(trigPin, LOW); long duration = pulseIn(echoPin, HIGH); int distance = duration * 0.034 / 2; return distance; arduino sensor shield v5 0 manual

#include <Servo.h> Servo myservo; const int trigPin = 8; const int echoPin = 9; int pos = 0; void loop() // Sweep from 0 to 180

The reset button on the shield should align perfectly with the reset button on the Arduino. The USB port on the Arduino should stick out the "short side" of the shield. This expansion board (or "shield") is designed to

Enter the . This expansion board (or "shield") is designed to solve exactly this problem. It turns your messy breadboard into a clean, plug-and-play hub for sensors and servos.

Place the shield over the pins. Press down evenly on the edges. You should hear a "click" as the plastic clips (if present) engage.