Hx8872-c: Datasheet

Check VSYNC and HSYNC polarity. The datasheet indicates that the HX8872-C can accept positive or negative edges, but you must configure the “Display Timing Control” register (0xB0) accordingly.

In RGB mode, yes. The HX8872-C has no internal RAM; it refreshes directly from the incoming pixel stream. Your MCU must continuously send data. hx8872-c datasheet

HX8872-C application note, HX8872-C vs ILI9341, HX8872-C pinout, HX8872-C Arduino library, HX8872-C replacement. Copyright notice: This article is for educational and engineering purposes. Refer to the official HX8872-C datasheet for absolute specifications. Himax Technologies retains all rights to the original datasheet content. Check VSYNC and HSYNC polarity

// Assume LCD_RST, LCD_CS, LCD_RS (D/C) defined void HX8872C_Init(void) // Hardware reset HAL_GPIO_WritePin(LCD_RST_GPIO_Port, LCD_RST_Pin, GPIO_PIN_RESET); HAL_Delay(10); HAL_GPIO_WritePin(LCD_RST_GPIO_Port, LCD_RST_Pin, GPIO_PIN_SET); HAL_Delay(120); // Send commands via SPI or MCU interface WriteCommand(0x11); // Sleep out HAL_Delay(120); WriteCommand(0x36); WriteData(0x00); // Normal orientation WriteCommand(0x3A); WriteData(0x05); // 16-bit RGB WriteCommand(0x29); // Display on The HX8872-C has no internal RAM; it refreshes